Feeds:
Pos
Komentar

Archive for Desember, 2016

SNTTM XVI bertujuan untuk mempertemukan para peneliti, profesional industri, dan mahasiswa pascasarjana dari disiplin ilmu Teknik Mesin. SNTTM XVI menawarkan lingkungan yang menarik dan merangsang peserta berdiskusi dan bertukar pikiran mengenai hasil penelitian ilmiah terbaru. Pada tahun 2017 ini, seminar diselenggarakan oleh Jurusan Teknik Mesin, Institut Teknologi Sepuluh Nopember (ITS) Surabaya, yang akan diselenggarakan pada tanggal 5-6 Oktober 2017 di Surabaya. Atas nama penyelenggara seminar, kami dengan senang hati mengundang semua peneliti dan ahli terkait lainnya, untuk menghadiri dan memberikan kontribusi dalam SNTTM XVI.

Makalah yang terpilih (selected paper) akan dipublikasikan dalam Jurnal Teknik Mesin dan semua makalah yang telah dipresentasikan dalam SNTTM XVI akan diterbitkan melalui IPTEK Journal of Proceedings Series.

Tanggal Penting

Batas waktu penyerahan abstrak
5 Juni 2017
Pemberitahuan penerimaan
17 Juli 2017
Batas waktu penyerahan makalah lengkap
4 Sep 2017
Batas waktu pendaftaran
22 September 2017
Tanggal seminar
5-6 Oktober 2017

Kunjungi laman http://seminar.bkstm.org/

Iklan

Read Full Post »

Abstract. Nowadays, the wood punching machine that is commonly used in small- scale furniture industry has a lot of deficiencies. Most of the industries still use makeshift machines to reduce the investment cost, thus the efficiency and the engine performance in terms of production speed is very low. One of the ways to resolve the problem is designing and manufacturing a prototype the drill press machine with low-cost material. The aims of this research are to design and manufacture a prototype the drill press machine with low-cost material to speed up the process of making the holes, increasing daily production and obtaining more precise cutting quality. The Method that used in this research includes designing the machine, making production drawing for its parts, manufacturing mechanical parts, and integrating electrical components and accessories by considering the use of the materials that are easy to obtain at the market. The results of tests performed in two different workshop furniture businesses show that by using the machine in the manufacturing of 12mm x 120mm sized holes with a depth of 70mm, a decrease in the average processing time of 1.03 minutes compared to the conventional machine. In term of the precision, the measured results along the hole shows that the difference between the end of the hole to within around 0.1mm.

Keywords: Prototype, furniture, industry, machine

Link: http://ojs.uho.ac.id/index.php/dinamika/article/view/1720

dinamika_pelubang_kayu

Read Full Post »

ABSTRACT. Energy distribution process on any of thermal machine commonly occurs within four parts. From the total energy which produced by combustion, only 20 of 100 percent used to generating shaft power, and the remaining is wasted. 30 percent of the wasted energy is emitted with exhaust gas. The exhaust gas temperature (EGT) type Ranger 2 cylinder can rise at 300oC at full rate and above depends on the engine load. The heat production from this process can be treating as a heat source (heater). The liquid water is drained into a shaped-coil pipe and collected in such high EGT to increase the enthalpy. The tool with a simple design can serve as a water heater which economical because its employs the exhaust heat from the operating engine.

Keywords : diesel engine, energy ,exhaust gas temperature (EGT)

presentasi-seminar

Read Full Post »